:: Re: [DNG] Assigning a specific subn…
Top Page
Delete this message
Reply to this message
Author: Steve Litt
Date:  
To: dng
Subject: Re: [DNG] Assigning a specific subnet and address to a Devuan Beowulf Qemu guest

On Wed, 17 Feb 2021 11:43:56 -0700
Gabe Stanton via Dng <dng@???> wrote:

> On Wed, 2021-02-17 at 11:26 -0700, Gabe Stanton via Dng wrote:
> > On Tue, 2021-02-16 at 07:55 -0500, Steve Litt wrote:
> > > Thanks Ralph,
> > > I had left them both out, but putting them in didn't change
> > > thesymptom. I tried with only auto eth0, and that didn't change
> > > thesymptom either.
> > > Thanks,
> > > SteveT
> > > Steve Litt
> >
> >
> > Just want to throw this out there in case it helps even a bit.
> >
> > I have a devuan vm running on a devuan host, I believe virt-manager
> > handled network setup for me, but in any case, below are the
> > contents of my /etc/network/interfaces files from both the host and
> > the vm. (notice on the host they have br0 config'd here instead of
> > eth0, don't know if you were referring to that file on the host or
> > the VM.)
> >
> > Host:
> >
> > auto br0
> > iface br0 inet dhcp
> >     bridge-ports eth0

> >
> >
> >
> >
> >
> > VM:
> > # This file describes the network interfaces available on your
> > system # and how to activate them. For more information, see
> > interfaces(5).
> >
> > source /etc/network/interfaces.d/*
> >
> > # The loopback network interface
> > auto lo
> > iface lo inet loopback
> >
> > # The primary network interface
> > allow-hotplug eth0
> > iface eth0 inet dhcp
> >
> >
> >
> >
> > anyway, hope that helps.
> >
> > Gabe
> >
> >
> >
> >
> > _______________________________________________Dng mailing
> > listDng@???
> > https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
>
> Just to be clear, my VM ip address is as you would like yours to be,
> it is a dhcp address from the pool on my router. So my host is
> 192.168.1.x and my vm is 192.168.1.y, and the VM is accessible from
> the network.


Hi Gabe,

On your guest VM, what does it say your default route is when you
perform the ip route command?

Did you need to do something special to get that default route
(gateway)?

Thanks,

SteveT

Steve Litt
Autumn 2020 featured book: Thriving in Tough Times
http://www.troubleshooters.com/thrive