:: Re: [DNG] Ethernet names revisited
Forside
Slet denne besked
Besvar denne besked
Skribent: dng@d404.nl
Dato:  
Til: dng
Emne: Re: [DNG] Ethernet names revisited
On 12-12-2020 14:15, Antony Stone wrote:
> Hi.
>
> I've just installed a couple of Beowulf systems, each of which has three
> ethernet interfaces; one on the motherboard, and two on a PCI card.
>
> I'm trying to work out how to give those interfaces the names I want; the
> motherboard as eth0, and the PCI card as eth1 / eth2.
>
> Historically, I've been used to udev and /etc/udev/rules.d/70-persistent-
> net.rules doing this, where I can specify the name I want for each interface
> according to its MAC address.
>
> The file didn't exist (although the directory did) on my Beowulf system, so I
> created one with the appropriate contents, and I now get messages while the
> kernel is booting:
>
> udevd[441]: Error changing net interface name eth2 to eth0: File exists
> udevd[441]: could not rename interface '4' from 'eth2' to 'eth0': File exists
> udevd[438]: Error changing net interface name eth1 to eth2: File exists
> udevd[438]: could not rename interface '3' from 'eth1' to 'eth2': File exists
> udevd[445]: Error changing net interface name eth0 to eth1: File exists
> udevd[445]: could not rename interface '2' from 'eth0' to 'eth1': File exists
>
> I've followed the entire thread on this list from July 2018 about this, which
> I've found _some_ of in the archives at
> https://lists.dyne.org/lurker/message/20180715.200323.7a2473a2.en.html however
> that link shows only a very small proportion of the emails in the discussion
> for some reason (I have my own local copy in my mail client).
>
> According to https://wiki.debian.org/NetworkInterfaceNames the old 70-
> persistent-net.rules system _should_ still work in Buster / Beowulf, but I
> can't work out how to get it to do so.
>
> I _have_ tried adding "net.ifnames=0" to the kernel boot line; this makes no
> difference.
>
> So:
>
> 1. how can I get 70-persistent-net.rules to carry on working under Beowulf?
>
> 2. what's the "correct" way to get my interfaces named the way I want,
> according to their MAC addresses, under Beowulf?
>
> (The above Debian wiki document indicates that Buster is the last release
> which will continue to support this, so I'm assuming I'll need to do something
> else for Chimaera; what is it?)
>
>
> Thanks,
>
>
> Antony.
>

From what I understand after some research you need a additional
/etc/udev/rules.d/10-network.rules as follow:

|SUBSYSTEM=="net", ATTR{address}=="90:e6:ba:01:00:01", NAME="eth0"
SUBSYSTEM=="net", ATTR{address}=="90:e6:ba:01:00:02", NAME="eth1"|
||SUBSYSTEM=="net", ATTR{address}=="90:e6:ba:01:20:01", NAME="eth2" Hope
this helps. Grtz Nick | |