On 1/15/23 18:45, tempforever wrote:
> Fred wrote:
>> On 1/15/23 13:54, dng@??? wrote:
>>> On 15-01-2023 21:51, Fred wrote:
>>>> Hi,
>>>>
>>>> I have used instructions at https://arm-files.devuan.org/README.txt
>>>> to install Beowulf 3.1.0 on a rpi2.  The image apparently booted ok
>>>> but I am not able to login.  The instructions for login (page 2) on
>>>> rpi appear to say username pi, password board.  However, this is not
>>>> accepted.  I have also tried devuan, toor which is also not
>>>> accepted. So, does anyone know what what login to use?
>>>>
>>>> Best regards,
>>>> Fred
>>>
>>> AFAIR it is root with toor.
>>>
>>> Grtz.
>>>
>>> Nick
>>>
>>> _______________________________________________
>>> Dng mailing list
>>> Dng@???
>>> https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
>> The instructions in the README above say the image is set up to
>> prevent root login initially.  One has to log in as some user,
>> password which is not clearly indicated, at least to me, and then use
>> sudo to become root.
>>
>> Best regards,
>> Fred
>>
>> _______________________________________________
>> Dng mailing list
>> Dng@???
>> https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
> Did you try user, devuan pass, devuan ?  That's listed on the above
> README.txt for Beowulf 3.0.0 and Chimaera 4.0.0 (but not for Beowulf
> 3.1.0) ... I believe that was also the default for Ascii 2.0.
> _______________________________________________
> Dng mailing list
> Dng@???
> https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
Hi,
None of those work. I had already tried devuan, pass, and password in
various combinations. Along with pi, board.

Best regards,
Fred