It should be. I had the same problem a little over a month ago and that
fixed it for me. Been running fine since.
On Mon, 2020-07-06 at 00:39 +1000, Andrew McGlashan via Dng wrote:
> Hi,
>
> Okay, not fully fixed after reboot... apparmor gave problems as
> previously discussed on the list.
>
> Also needed to adjust:
>
> /etc/apparmor.d/local/usr.sbin.named
>
>
> Added a line:
>
> /var/lib/named/** rw,
>
>
> Then restarted apparmor service:
>
> service apparmor reload
>
>
> And then bind would start properly, immediately and again after
> another reboot.
>
>
> Should it be all good now?
>
>
> Thanks
> A.
>
>
> On 6/7/20 12:04 am, Andrew McGlashan via Dng wrote:
> > Hi,
> >
> > I just upgraded fron Devuan ascii to beowulf with the server
> > running bind9 in a chroot environment and bind would not start.
> >
> >
> > _This was the relevant error in /var/log/daemon.log_
> >
> > Jul 5 23:36:43 bind9-server-name named[6476]: *could not
> > configure root hints from '/usr/share/dns/root.hints': file not
> > found*
> > Jul 5 23:36:43 bind9-server-name named[6476]: *loading
> > configuration: file not found*
> > Jul 5 23:36:43 bind9-server-name named[6476]: *exiting (due to
> > fatal error)*
> >
> >
> > _Fixed as follows:_
> >
> > # mkdir -p /var/lib/named/usr/share/dns
> > # cp -pv /usr/share/dns/* /var/lib/named/usr/share/dns/
> >
> >
> > _NB: No upgrade changes were made to any config file including the
> > /etc/default/bind9 file below._
> >
> > # cat /etc/default/bind9
> >
> > # Set RESOLVCONF=no to not run resolvconf
> > RESOLVCONF=yes
> >
> > # startup options for the server
> > #OPTIONS="-u bind"
> >
> >
> > # Added -t ... for running of bind9 in a chroot environment
> > #OPTIONS="-u bind -t /var/lib/named"
> > # Added -4 to foce IPV4 lookups only
> > OPTIONS="-u bind -4 -t /var/lib/named"
> >
> > ### NB: This symbolic link is needed for the chroot environment
> > too
> > # (without needing to change /etc/init.d/bind9 file)
> > #
> > # cd /run/named
> > # ln -s /var/lib/named/run/named/named.pid .
> >
> >
> > Kind Regards
> > AndrewM
>
> _______________________________________________
> Dng mailing list
> Dng@???
> https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
::
Re: [DNG] Upgrade problem [ ascii -…
