From: Tony Lindgren <tony@???>

[ Upstream commit 4abd9930d189dedaa59097144c6d8f623342fa72 ]

Looks like we can have the maxtouch touchscreen stop producing interrupts
if an edge interrupt is lost. This can happen easily when the SoC idles as
the gpio controller may not see any state for an edge interrupt if it
is briefly triggered when the system is idle.

Also it looks like maxtouch stops sending any further interrupts if the
interrupt is not handled. And we do have several cases of maxtouch already
configured with a level interrupt, so let's do that.

With level interrupt the gpio controller has the interrupt state visible
after idle. Note that eventually we will probably also be using the
Linux generic wakeirq configured for the controller, but that cannot be
done until the maxtouch driver supports runtime PM.

Cc: maemo-leste@???
Cc: Arthur Demchenkov <spinal.by@???>
Cc: Ivaylo Dimitrov <ivo.g.dimitrov.75@???>
Cc: Merlijn Wajer <merlijn@???>
Cc: Pavel Machek <pavel@???>
Cc: Sebastian Reichel <sre@???>
Signed-off-by: Tony Lindgren <tony@???>
Signed-off-by: Sasha Levin <sashal@???>
---
arch/arm/boot/dts/motorola-mapphone-common.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/motorola-mapphone-common.dtsi b/arch/arm/boot/dts/motorola-mapphone-common.dtsi
index da6b107da84a4..aeb5a673c209e 100644
--- a/arch/arm/boot/dts/motorola-mapphone-common.dtsi
+++ b/arch/arm/boot/dts/motorola-mapphone-common.dtsi
@@ -413,7 +413,7 @@
         reset-gpios = <&gpio6 13 GPIO_ACTIVE_HIGH>; /* gpio173 */

         /* gpio_183 with sys_nirq2 pad as wakeup */
-        interrupts-extended = <&gpio6 23 IRQ_TYPE_EDGE_FALLING>,
+        interrupts-extended = <&gpio6 23 IRQ_TYPE_LEVEL_LOW>,
                       <&omap4_pmx_core 0x160>;
         interrupt-names = "irq", "wakeup";
         wakeup-source;
-- 
2.20.1