:: Re: [DNG] ifstat.eth0 on Boot
Pàgina inicial
Delete this message
Reply to this message
Autor: Dr. Nikolaus Klepp
Data:  
A: dng
Assumpte: Re: [DNG] ifstat.eth0 on Boot
Am Mittwoch, 12. Dezember 2018 schrieb Didier Kryn:
> Le 12/12/2018 à 13:58, Dr. Nikolaus Klepp a écrit :
> > Am Dienstag, 11. Dezember 2018 schrieb Gonzalo Pérez de Olaguer Córdoba:
> >> Hi Michael K.
> >>
> >> El Fri, 7 Dec 2018 12:45:11 +0100
> >> "Michael K." <michael@???> escribió:
> >>
> >>> After a Dev1 Setup on a Laptop (whit eth0), i have to wait a long time
> >>> for the eth0 on "cold boot".
> >>>
> >>> I "cold boot" my Laptop
> >>> I look to the "Boot Messages"
> >>> I see the following Msg:
> >>>
> >>> Configuring Network Interfaces ifup: Waiting for Lock on
> >>> /run/network/ifstat.eth0
> >>>
> >>> After 2 or 3 minutes to wait, the Laptop boot up,
> >> Just in case this could help, I've been having this same *symptom*
> >> on KVM virtual machines running ascii.
> >>
> >> My situation was eth0 being configured through DHCP and using the
> >> dhcp client from the isc-dhcp-client package, which sends (maybe buggy)
> >> DHCPDECLINE packets.
> >>
> >> My workaround was to replace isc-dhcp-client with pump.
> >>
> >> If you want more details, tell me and I will continue writing.
> >>
> >> Bye,
> >> Salo.
> >>
> > Now this is a neet tick! It also solves the issue that booting hangs on the said message when no network cable is attached to eth0.
> >
> > Nik
> >
>     Is it as simple as apt-get remove isc-dhcp-client; apt-get install
> pump ?


Yes, but I first installed pump and then purged isc-dhcp-client.


--
Please do not email me anything that you are not comfortable also sharing with the NSA, CIA ...