:: Re: [DNG] ifconfig vs ip
Página Principal
Delete this message
Reply to this message
Autor: Simon Walter
Data:  
Para: dng
Assunto: Re: [DNG] ifconfig vs ip
On 06/06/2016 08:48 PM, Rainer Weikusat wrote:
> Simon Walter <simon@???> writes:
>> On 06/05/2016 12:16 AM, Rainer Weikusat wrote:
>>> Simon Walter <simon@???> writes:
>>>
>>> [...]
>>>
>>>> I am adding containers (LXC) and
>>>> virtual network to the box, I think I will add an tap and bridge
>>>> interface to an /etc/network/interface.d/ file. If I use something
>>>> like:
>>>>
>>>> auto br0
>>>> iface br0 inet static
>>>>       pre-up ip tuntap add dev tap0 mode tap
>>>>       pre-up ip link set tap0 up
>>>>       post-down ip link set tap0 down
>>>>       post-down ip tuntap del dev tap0 mode tap
>>>>       bridge_ports tap0
>>>>       address 10.1.1.1
>>>>       netmask 255.255.255.0
>>>>       broadcast 10.1.1.255

>>>>
>>>> And make sure there is the source /etc/network/interface.d/* line in
>>>> the interfaces file. Then route with iptables between the a physical
>>>> NIC (eth0 for example) and the virtual NIC (tap0) and have all the
>>>> containers connected to br0.
>>>>
>>>> Are there any glaring problems with this setup?
>>> This will create a bridge with one virtual network interface bridged to
>>> a character device an application could use to talk 'ethernet' to the
>>> network stack. That's certainly not inherently related to/ useful for
>>> anything-lxc.
>>>
>> I will route the packets to the physical device using iptables,
>> thereby creating a firewalled private network. I have only tried it
>> out and not done much research and testing on whether this is actually
>> secure or not.
> You don't need the tap port for that, the bridge will happily work
> without any ports statically assigned to it.


And will I be able to set up iptables with just the bridge? I was
thinking of using shorewall. I've never used it before, but it seems
like it's configuration is easy to maintain. Therein lies my concern.
There are zones with interfaces for each zone. For some reason I thought
a bridge needs to at least have one interface that it is bridging for it
to be up. Can I bring a bridge up and do iptables stuff with it having
no interfaces that it bridges?

>
> The machines I'm dealing with use a bridge as 'main interface' a
> principally arbitrary number of (lxc) containers connect to via veth
> with one physical interface also assigned to the bridge to provide
> actual connectivity. It's also possible to do packet filtering between
> bridge ports if that's considered to be desirable/ useful.


I want to filter packets between physical NIC (WAN, eth0) and a virtual
internal network (LAN, br0/tap0???). I am basically creating an isolated
virtual network with virtual machines all inside one machine. Each
container will have just enough software to carry out it's place in the
network. Thereby isolating everything as much as possible, allowing for
independent updates, modifications, hotswaps, etc.

> 'Introduction
> site'
>
> http://ebtables.netfilter.org/
>
> One of the advantages of ip(route) over the older, BSD-style tools is
> that they can be used to assign an arbitrary number of protocol
> addresses to a single interface without employing 'interface aliases'.


Good to know. Thank you!

Simon