Doh! I tried changing wlan0 to wlan1 in /etc/network/wifi/<essid>, but I
didn't think to change it in /etc/network/interfaces. Rebooting now to
test it.

-fsr


On 10/12/2015 10:50 AM, Edward Bartolo wrote:
> Hi fsmithred,
>
> I have just seen the code for disconnect and it looks it should work
> even for wlan1. There is a good indication the problem is caused
> because we have to add:
>
> iface wlan1 inet dhcp
>
> to your /etc/network/interfaces file.
>
> The same applies for eth1. You have to add
>
> iface eth1 inet dhcp
>
> to your /etc/network/interfaces.
>
> Similarly, for other numbers.
>
> Probably, other config statements work, but it is clear ifdown
> requires any device used to be configured in /etc/network/interfaces
> so as it would be recognized.
>
> Edward
>
> On 12/10/2015, Edward Bartolo <edbarx@???> wrote:
>> OK, I will debug that and then upload the required changes.
>>
>> Edward.
>>
>> On 12/10/2015, fsmithred <fsmithred@???> wrote:
>>> It's working, mostly. I can switch the default interface between wlan0
>>> and
>>> wlan1 through the gui, and it connects correctly, but disconnect only
>>> works with wlan0. With wlan1, it says it's disconnecting, but it doesn't
>>> succeed.
>>>
>>> -fsr
>>>
>>>
>>>
>>> On 10/11/2015 05:44 PM, Edward Bartolo wrote:
>>>> Hi,
>>>>
>>>> I have just git pushed my latest changes to netman GUI and the backend
>>>> which now should support wlanN and eth0...eth3 (till now).
>>>>
>>>> This was a complex modification, so undiscovered bugs may still be
>>>> lurking. Please, give your feedback, especially positive, and
>>>> suggestions for improvement. At the moment, I am using the latest
>>>> version and it seems to work, but I do NOT use wlanN or ethN with N >
>>>> 0. I tested the backend and frontend momentarily by modifying udev
>>>> .rules to rename wlan0 to wlan1, and it worked, at least in my case.
>>>> Hopefully, it works also for all of you.
>>>>
>>>> Edward
>>>>
>>>
>>>
>>