:: Re: [DNG] Git pushed latest changes…
Top Pagina
Delete this message
Reply to this message
Auteur: Edward Bartolo
Datum:  
Aan: fsmithred
CC: dng
Onderwerp: Re: [DNG] Git pushed latest changes to backend and netman GUI.
Hi fsmithred,

I have just seen the code for disconnect and it looks it should work
even for wlan1. There is a good indication the problem is caused
because we have to add:

iface wlan1 inet dhcp

to your /etc/network/interfaces file.

The same applies for eth1. You have to add

iface eth1 inet dhcp

to your /etc/network/interfaces.

Similarly, for other numbers.

Probably, other config statements work, but it is clear ifdown
requires any device used to be configured in /etc/network/interfaces
so as it would be recognized.

Edward

On 12/10/2015, Edward Bartolo <edbarx@???> wrote:
> OK, I will debug that and then upload the required changes.
>
> Edward.
>
> On 12/10/2015, fsmithred <fsmithred@???> wrote:
>> It's working, mostly. I can switch the default interface between wlan0
>> and
>> wlan1 through the gui, and it connects correctly, but disconnect only
>> works with wlan0. With wlan1, it says it's disconnecting, but it doesn't
>> succeed.
>>
>> -fsr
>>
>>
>>
>> On 10/11/2015 05:44 PM, Edward Bartolo wrote:
>>> Hi,
>>>
>>> I have just git pushed my latest changes to netman GUI and the backend
>>> which now should support wlanN and eth0...eth3 (till now).
>>>
>>> This was a complex modification, so undiscovered bugs may still be
>>> lurking. Please, give your feedback, especially positive, and
>>> suggestions for improvement. At the moment, I am using the latest
>>> version and it seems to work, but I do NOT use wlanN or ethN with N >
>>> 0. I tested the backend and frontend momentarily by modifying udev
>>> .rules to rename wlan0 to wlan1, and it worked, at least in my case.
>>> Hopefully, it works also for all of you.
>>>
>>> Edward
>>>
>>
>>
>