:: Re: [dyne:bolic] Driver
Página superior
Eliminar este mensaje
Responder a este mensaje
Autor: Richard Griffith
Fecha:  
A: dynebolic
Asunto: Re: [dyne:bolic] Driver
Perhaps you need to force db to load the kernel module for the C-Media
card. The snd module in the ALSA message won't be available if the
kernel module for the card doesn't load. Try issuing this command:

modprobe snd-cmipci

Then see if you get sound.

This article specifically mentions a related C-Media card:
http://spot.river-styx.com/viewarticle.php?id=14

Good luck,
-Richard

On 03/27/2011 02:57 PM, Pablo Ferreira wrote:
>
> Hola, sigo molestando!
>
> In the directory
>
> /mnt/hd1/1/dyne/SDK/sys/share/alsa/cards         I found the CMI8338.conf which says "Configuration for the CMI 8338/8738 Chip ...."

>
> But when I execute alsaconf -p CMI8338 or CMI8738 the output is "modinfo: could not find module snd"
>
> The output for lspci is:
>
>
>
>
>
>
>
>
>
>
>
>
>    00:00.0 Host bridge: VIA Technologies, Inc. VT8378 [KM400/A] Chipset Host Bridge
>    00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI Bridge
>    00:09.0 Multimedia audio controller: C-Media Electronics Inc CM8738 (rev 10)
>    00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
>    00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
>    00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
>    00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
>    00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
>    00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
>    00:11.6 Communication controller: VIA Technologies, Inc. AC'97 Modem Controller (rev 80)
>    00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 74)
>    01:00.0 VGA compatible controller: VIA Technologies, Inc. VT8378 [S3 UniChrome] Integrated Video (rev 01)

>
>
>
> When i execute alsaconf the output is:
>
>
>
>
>
>
>
>
>
>
>
>
>
>    modinfo: could not find module snd
>    modinfo: could not find module snd
>    modinfo: could not find module snd
>    /usr/sbin/alsaconf: line 681: /usr/bin/awk: cannot execute binary file

>
>
> My knowledgment is very limited at this moment, i expect someone can help me. thanks
>
> Saludos
>
>                       
> _______________________________________________
> dynebolic mailing list
> dynebolic@???
> http://lists.dyne.org/mailman/listinfo/dynebolic
>