:: Re: [dyne:bolic] Midisport
Αρχική Σελίδα
Delete this message
Reply to this message
Συντάκτης: Benjamin Hardy
Ημερομηνία:  
Προς: dynebolic mailinglist
Αντικείμενο: Re: [dyne:bolic] Midisport

Hello,
I have an Oxygen8, and by looking at the usb-midi-fw webpage I presume this applies to me as well. I am unfamiliar with installing additional applications in dyne:bolic but have some experiance installing in other linux distros. So, all I have to do is open a xconsole and ./configure , make, and make install? This would require that I have dyne docked in my C: drive or could I install in a nest? I'm more unfamiliar with udev rules, but I'll consider trying this. The other alternative for me is just using energyxt in Windows, which I'll also install in linux when I get my own computer... in the future.




----------------------------------------
> Date: Tue, 5 Jun 2007 19:56:25 +0100
> From: support@???
> To: dynebolic@???
> Subject: [dyne:bolic] Midisport
>
> Hi all,
> I have been lurking for a while and playing with dyne/pure:dyne. I must
> say that I am very impressed with the O/S and I am eager to get further
> away from M$ babylon :) Currently I have pure:dyne installed, but the
> problem seemed the same with dyne 2.4.2 as well.
>
> My question concerns getting my USB midi interface, a Midisport 2x2,
> working at boot up. I will detail the process I have followed so for so
> that you know how I got to this stage!
>
> I have downloaded the firmware from here:
>
> http://usb-midi-fw.sourceforge.net/
>
> and done the usual /.configure, make, make install.
>
> I got stuck because the usbfs wasnt being mounted. But I found a support
> ticket at p:d's wiki which said to mount /proc/bus/usb. Once I did this
> then everything went well, the firmware is loaded and then the interface
> is seen by all of my MIDI applications.
>
> The problem comes when I reboot the computer, the interface is not loaded
> again. The symptoms are the same whether the interface is connected at
> boot or when plugging it in after dyne has booted.
>
> After a bit of playing around I realised that the firmware loader puts a
> file in /etc/udev/rules.d/. As long as this file is in the folder then I
> can plug and unplug the interface no problems, it is detected and runs
> fine. But after rebooting I have to run the whole make install procedure
> again to restore the file which gets deleted. I presume this is an issue
> connected to the udev folder not being stored in the nest? (but I'm still
> learning, so please do tell if I'm wrong!).
>
> Does anyone have an idea of how I could set this up better?
>
> TIA for any help, and for providing such an excellent system to play with
>
> David Moss
> _______________________________________________
> dynebolic mailing list
> dynebolic@???
> http://lists.dyne.org/mailman/listinfo/dynebolic


_________________________________________________________________
Explore the seven wonders of the world
http://search.msn.com/results.aspx?q=7+wonders+world&mkt=en-US&form=QBRE