hi Farasha
you are not passing the correct kernel parameters to the dynebolic kernel,
I think you are simply extracting the dyne folder to your hard disk, and
then giving grub the
kernel and initrd as -
kernel /dyne/linuxbox
initrd /dyne/initrd.gz

check out the isolinux.cfg file also on the cd, in the isolinux folder, or
somwhere it contains exact the parameters you need to pass to the kernel
like the root file system etc..
dyne wont boot without them.

xask wuz here
Deepak Mishra

On 10/03/07, Farasha Euker <farasha1@???> wrote:
>
> I have tried booting the new 2.4.1 from the cd on four different
> computers,
> burned on two different cd writers and downloaded twice from two different
> servers with both passing check sum validation. All four computers
> run 2.4and earlier flawlessly and all four also run
> 2.4.1 flawlessly if the iso is extracted, copied to a dyne directory on
> the
> hdd and booted via grub. The error is the same on all machines and
> basically is a few messages saying modules couldn't be loaded, then xinit
> couldn't be found, then I am dumped to a barely functional shell since
> even
> zsh won't start. I would appreciate any help I could get in resolving
> this
> matter.
> Thank you.
>
> --
> "Simplicity of life, even the barest, is not a misery, but the very
> foundation of refinement; a sanded floor and whitewashed walls and the
> green
> trees, and flowery meads, and living waters outside."
> - William Morris
> _______________________________________________
> dynebolic mailing list
> dynebolic@???
> http://lists.dyne.org/mailman/listinfo/dynebolic
>