:: Re: [dyne:bolic] DNS problem?
Página superior
Eliminar este mensaje
Responder a este mensaje
Autor: Kristofer Dale
Fecha:  
A: dynebolic
Asunto: Re: [dyne:bolic] DNS problem?

I forgot which driver I was testing in my previous post, I should have said
dfme. I'm still on the same computer, but now running v1.4.1, and here is
the output, pretty much identical to that when running v2.3:

[d:b] ~ #ifconfig
eth0      Link encap:Ethernet  HWaddr 00:80:AD:78:F6:87
           inet addr:192.168.0.5  Bcast:192.168.0.255  Mask:255.255.255.0
           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
           RX packets:902 errors:260 dropped:0 overruns:0 frame:0
           TX packets:1109 errors:14 dropped:0 overruns:0 carrier:14
           collisions:0 txqueuelen:1000
           RX bytes:357231 (348.8 Kb)  TX bytes:110830 (108.2 Kb)
           Interrupt:3 Base address:0xb000


lo        Link encap:Local Loopback
           inet addr:127.0.0.1  Mask:255.0.0.0
           UP LOOPBACK RUNNING  MTU:16436  Metric:1
           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
           collisions:0 txqueuelen:0
           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)


[d:b] ~ #route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        0 eth0
0.0.0.0         192.168.0.1     0.0.0.0         UG    0      0        0 eth0


[d:b] ~ #lspci
00:00.0 Host bridge: ALi Corporation M1541 (rev 04)
00:01.0 PCI bridge: ALi Corporation M1541 PCI to AGP Controller (rev 04)
00:02.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03)
00:03.0 Bridge: ALi Corporation M7101 Power Management Controller [PMU]
00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV] (rev c3)
00:09.0 Ethernet controller: Davicom Semiconductor, Inc. 21x4x DEC-Tulip compatible 10/100 Ethernet (rev 31)
00:0a.0 Multimedia audio controller: Aureal Semiconductor AU8810 Vortex
Digital Audio Processor (rev 02)
00:0b.0 Multimedia video controller: Zoran Corporation ZR36057PQC Video
cutting chipset (rev 02)
00:0f.0 IDE interface: ALi Corporation M5229 IDE (rev c1)
01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS] 86C326
5598/6326 (rev 0b)

[d:b] ~ #cat /etc/resolv.conf
search dyne.org
nameserver 205.171.3.65
nameserver 205.171.2.65

[d:b] ~ #dmesg|grep -i eth
eth0: Davicom DM9102/DM9102A rev 49 at 0xcacfb000, 00:80:AD:78:F6:87, IRQ 3.
eth0: Setting full-duplex based on MII#1 link partner capability of 45e1.

I can ping everything everywhere near and wide, and the only difference I
can tellso far between v1.4.1 and the v2.x series is that I can only ping
the address assigned dynamically to eth0 by the gateway when I'm running
v2.x, nothing else responds...

.
.        _o              Kristofer Dale,
.     _ \<,_             ragged individualist,
.    ( )/ ( )            statistic at large...
.