:: Re: [dyne:bolic] net configuration
Góra strony
Delete this message
Reply to this message
Autor: daftwight
Data:  
Dla: dynebolic mailinglist
Temat: Re: [dyne:bolic] net configuration
Hi,

had problems connecting as well.

I changed my MTU to 1460 instead of 1500 and got connected.

in terminal:
#ifconfig ethX MTU 1460
#ifconfig ethX up
#dhcpcd ethX

That got me an IP address. Not very knowledgable in linux myself but....
for what its worth.

Jon

On 7/10/06, perke <perke11@???> wrote:
>
> try this in terminal: dhclient eth0
>
>
> On 7/10/06, Kristofer Dale <barefoot@???> wrote:
> >
> >
> > I have two networked desktops, one is a homebuilt 500mhz AMD processor
> > and
> > the other is an HP Pvilion that has been expanded. They share an
> > Actiontec
> > Gateway supplied by Qwest for the DSL service and are connected by
> > ethernet
> > cable. When I query with ifconfig, both Lumumba and Dhoruba report that
> > eth0 is "UP", here is the output:
> >
> > Lumumba
> >
> > eth0      Link encap:Ethernet  HWaddr 00:80:AD:78:F6:87
> >           inet addr:192.168.0.2  Bcast:192.168.0.255  Mask:255.255.255.0
> >           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
> >           RX packets:31367 errors:14093 dropped:0 overruns:0 frame:0
> >           TX packets:27224 errors:7 dropped:0 overruns:0 carrier:7
> >           collisions:0 txqueuelen:1000
> >           RX bytes:26746763 (25.5 Mb)  TX bytes:3764779 (3.5 Mb)
> >           Interrupt:3 Base address:0xb000

> >
> > Dhoruba
> >
> > eth0      Link encap:Ethernet  HWaddr 00:80:AD:78:F5:06
> >           UP BROADCAST NOTRAILERS MULTICAST  MTU:1500  Metric:1
> >           RX packets:6859 errors:14240 dropped:0 overruns:0 frame:0
> >           TX packets:508 errors:12 dropped:0 overruns:0 carrier:12
> >           collisions:0 txqueuelen:1000
> >           RX bytes:1517654 (1.4 Mb)  TX bytes:59179 (57.7 Kb)
> >           Interrupt:3 Base address:0xd000

> >
> >
> > I assume the fact that there is no line starting with "inet" has
> > something
> > to do with the problem, but I am not knowledgeable enough to do more
> > than
> > select the correct card and DHCP button in the config utility. Let me
> > know
> > if you need more information...
> >
> > _______________________________________________
> > dynebolic mailing list
> > dynebolic@???
> > http://mailinglists.dyne.org/mailman/listinfo/dynebolic
> >
>
>
> _______________________________________________
> dynebolic mailing list
> dynebolic@???
> http://mailinglists.dyne.org/mailman/listinfo/dynebolic
>
>
>



--
Jon
http://raw.rautemusik.fm